Liquidip model hardening liquid 1000ml

Liquidip model hardening liquid is a low-viscosity, alcohol-based preparation designed for surface preparation of models in a dental laboratory.

Features:

• excellent penetration, deeply penetrates the model structure;
• after applying the liquid, the model surface becomes hard and smooth, which significantly facilitates further work;
• additionally, the product improves wax adhesion during modeling.

Application:

To achieve optimal results, follow the procedure below:

• preparation of the investment model: the model cast from investment material must be completely set, clean, and free of dust.
• bath / application (cold): immerse the model for a few seconds in LIQUIDIP liquid;
• draining and drying (WITHOUT using high temperature): remove the model and drain excess liquid, leave the model to dry completely at room temperature of approx. 20°C for approx. 15 minutes. The alcohol contained in the liquid evaporates, leaving an internalized layer of resin on the surface, which smoothly hardens the coating.
• gel duplication (e.g., REPLIGEL) and wax modeling: after drying, the model is ready for duplication in duplicating gel. The hardened surface prevents damage to the model and significantly improves wax adhesion during construction application.

Packaging:

• 1000ml

Durofluid Bego 100 ml

Durofluid spray for hardening models.

Catalog number BEGO 52008

To increase the adhesion of wax-formed parts, investment models replicated in silicone can be dried at a temperature of approximately 70 °C – 100 °C for approximately 10 minutes.

The casting material models are then sprayed with a thin and even layer of Durofluid modelling spray.

Advantages:

• durofluid hardens dry models duplicated in the investment mass;
• provides the modeled work with better support.

Packaging:

• 100ml spray

Prohard Model Hardening Fluid 900ml

Prohard model hardening fluid.

Characteristics:

• liquid intended for hardening and tempering duplicated models made of investment materials;
• the preparation holds the wax well and does not react with preparations that reduce surface tension;
• shows good adhesion, the preparation is well absorbed into the replicated model, providing an optimally hardened, smooth surface for further processing.

How to use:

• dry the duplicated model at 120-150°C and then cool to 45°C;
• then dip twice in Prohard liquid for 10 seconds and leave to cool completely.

Packaging:

• 900ml

Durol Bego Model Hardening Liquid 1000ml

Preparation for hardening models.

Catalog number BEGO 52111

Does not contain solvent.

**Advantages:***

• when used cold, it penetrates very well into the surface of the replicated models during hardening;
• models are hard and smooth;
• The recommended drying temperature for the duplicate model is 250 °C.

Packaging:

• 1l

Bredent Hardener for Investment Masses 500ml

Spray hardener for cold use with all agar and silicone investment materials.

Characteristics:

• hard and smooth models made of investment materials;
• convenient, clean and fast duplication;
• guarantee of precise castings;
• using the hardener "cold" shortens the working time.

Instructions for use:

• After duplicating the investment model, dry it at 100-150 °C for about 30 minutes;
• then cool the model so that you can hold it comfortably in your hands and spread it on a paper towel;
• from a distance of approx. 30 cm, thinly spray the model with the hardener;
• Once dry, you can start modeling in wax.

Attention:

• flammable product.

Packaging:

• 1 pc./500ml