Repligel PG - agar for duplicating plaster models 6kg

Repligel PG is an agar-based material designed for duplicating plaster models.

Thanks to a special formula, the surface of the cast negative remains dry after the agar sets and does not react with the plaster model.

The material allows for high-quality duplicated models even with sharp contours and deep undercuts.

Repligel PG can be used multiple times like traditional agar - this allows for significant cost reduction in model duplication - we especially recommend it to technicians working with the thermal injection method for acetal and nylon.

Instructions:

• cut the gel into small pieces (the smaller the better), place in an agar melting machine or other melting device;
• heat to 90-95 °C while stirring constantly; stirring prevents lumps and helps achieve a uniform gel consistency;
• avoid overheating the gel (boiling) as it causes water evaporation and shortens the product's shelf life;
• to minimize water evaporation during heating, keep the melting machine closed;
• never add water during the first melting of the agar;
• after melting, the gel must be cooled to 47-48 °C;
• before duplicating, place the model in warm water for 15-20 minutes to "soak" it.

NOTE:

• before duplicating, the model surface must be absolutely dry to prevent water from the plaster surface from reacting with the agar;
• setting time at room temperature is approx. 1 hour;
• after releasing the model, the agar should be washed and stored in a closed container until next use - this process (washing) also replenishes water lost during melting;
• however, add 50-100ml of water per 6 kg of gel if the gel dries out during storage.

Features:

• accurate detail reproduction;
• tear-resistant;
• high durability;
• pink color.

Packaging:

• 6kg