Stratogel 3D - Insulator for 3D models 100ml

Isolator for 3D models.

Characteristics:

• gel, despite its viscosity, spreads easily on the surface, and after drying creates a thin layer;
• acts as a separating film between 3D resin and acrylic resin;
• has the appropriate viscosity, effective with just one layer;
• however, you can apply a second layer when dealing with rougher surfaces (printed models larger than 100 microns);
• the first layer must be completely dry;
• the plastic layer is easily removed with water and a brush.

STRATOGEL comes off without residue, does not damage acrylic resin and 3D resin, does not change the properties of resins, is safe and does not contain any toxic substances.

Advantages:

• easy application: a single layer is applied with a brush;
• creates a very thin insulating layer;
• does not contaminate 3D resin or acrylics;
• easily removed with water.

How to use:

• apply a few drops directly from the bottle to the dry model and spread evenly with a brush;
• For quick drying, it is recommended to dry the gel with compressed air at low pressure for 30 seconds, air drying for 30 minutes.

Packaging:

• 100ml